← Back to the recipe

Ingredients and steps on one page. Print it, or choose “Save as PDF” in the print dialog.

Sekai Gohan

Boiled Bream Fish, Zambian Style: Whole Fish Simmered on Banana Leaves with Tomato and Onion

A whole Zambian-style bream coated in a broth of tomato and onion
Steps with photos

Ingredients

Ingredient Amount Role
Whole bream 500–600 g The main ingredient. This is the weight of the whole fish, not the edible portion
Sunflower oil ½ cup (150 ml) Added with the water to form the cooking liquid
Ripe tomatoes 7 oz (200 g) Finely chopped. Layered under the fish to form the broth
Onion 3.5 oz (100 g) Finely chopped. Layered with the tomatoes
Iodized salt 1½ tablespoons Added all at once in step 5
Banana leaves 2–3 leaves Washed. Used to line the bottom of the pot
Water 1 quarts (1 L) The cooking liquid. Added all at once in step 4
Cooked plain nshima As needed Served separately on the side. Not part of the fish pot

Steps

  1. 1Gut and wash the whole fish

    Remove the intestines with a sharp knife, then wash the fish. Work on a board set aside for raw fish, away from the tomatoes and onion.

    This step covers only gutting and washing. If you are unsure whether the fish needs scaling or gill removal, check how it was prepared when you bought it, or ask the fishmonger to clean it for you. Afterwards, wash the knife, board and your hands with detergent and hot water before touching other ingredients.

  2. 2Line the bottom of the pot with banana leaves

    Lay the 2–3 washed banana leaves flat across the bottom of the heavy-bottomed pot. They are a lining, not a wrapping: the fish is not enclosed in the leaves at any point.

  3. 3Spread the onion and tomatoes over the leaves

    Place the 3.5 oz (100 g) finely chopped onion and 7 oz (200 g) finely chopped ripe tomatoes on top of the banana leaves.

    Banana leaves, not cabbage leaves

    This recipe uses banana leaves only, as in the ingredient list and step 2; no cabbage is added.

  4. 4Lay the fish on the vegetables and add the oil and water

    Place the whole cleaned fish on top of the onion and tomatoes. Pour in the ½ cup (150 ml) sunflower oil and the 1 quarts (1 L) water.

    Use the full amounts now, and don't top up with more water during cooking.

  5. 5Add the salt, cover, boil for 10 minutes, then simmer for 20

    Add all 1½ tablespoons of iodized salt to the pot. Put the lid on and bring it to a boil, letting it boil for 10 minutes. Then lower the heat and simmer, still covered, for another 20 minutes.

    These times cover only the heating stage, not preparation or the time to reach a boil. The thickness of the fish, the pot and your burner all change how fast heat reaches the center, so check it with the thermometer in step 6.

    The heat lowered, the covered pot simmering for 20 minutes
    After the boil, small steady bubbles at the edge rather than a rolling boil
  6. 6Check the thickest part with a thermometer, then serve

    When the cooking time is up, insert a clean food thermometer into the thickest part of the fish, angled to avoid the bone. Keep cooking until it reads 63°C (145°F).

    If the thickest part has not reached 145°F (63°C), put the lid back on, keep simmering and check again. Clean the thermometer between checks.

    Once it is done, lift the fish out carefully with a wide spatula so it does not break apart, and serve it with the tomato and onion broth. Serve plain nshima on the side, as explained below.