← Back to the recipe

Ingredients and steps on one page. Print it, or choose “Save as PDF” in the print dialog.

Sekai Gohan

Coconut Fish: The Fried Recipe Published by DBE as a Nauruan Dish

A golden white fish fillet in a lime-and-coconut crust, plated with a lime wedge
Steps with photos

Ingredients

Fish and marinade

Ingredient Amount Role
White fish fillets (cod or tilapia; boneless cod fillets used here) 900 g (2 lb) The main ingredient, marinated, coated and fried
Lime juice 1/4 cup (60 ml) Marinade, mixed with the salt and pepper
Sea salt 1 tsp (5 ml) Marinade seasoning
Black pepper 1 tsp (5 ml) Marinade seasoning

Coating

Ingredient Amount Role
All-purpose white flour 1 cup (240 ml) First layer, applied straight after the marinade
Eggs (whole) 2 Second layer, beaten together
Fine dried unsweetened coconut flakes 2 cups (480 ml) Final layer that becomes the crust (or 1 small coconut, grated)

Frying and serving

Ingredient Amount Role
Canola oil As needed For frying the coated fish in the skillet
Flake sea salt To taste Finishing salt, separate from the marinade salt
Lime wedges To serve Squeezed at the table, separate from the marinade juice

Steps

  1. 1Marinate the fish briefly in lime, salt and pepper

    In a shallow dish, mix 1/4 cup (60 ml) lime juice, 1 tsp sea salt and 1 tsp black pepper. Add the fish, turn it to coat, and leave it in the refrigerator for 5 to 10 minutes, since this is raw fish.

    The lime does not cook the fish. This marinade is for flavor only, and the fish still needs to be fully cooked in step 4.

  2. 2Set up the three coating dishes

    While the fish marinates, set out three shallow plates: one with 1 cup (240 ml) all-purpose flour, one with the 2 eggs beaten together, and one with 2 cups (480 ml) coconut flakes. Arrange them in that order, ending next to the stove, and keep the plate for the cooked fish on the other side, away from the raw fish and egg.

  3. 3Coat each piece in flour, then egg, then coconut

    Lift one piece of fish out of the marinade and let the excess liquid drip off. Lay it in the flour and turn it until every side is covered with a light, even layer.

    Next, dip the floured fish into the beaten egg, letting the excess drip back into the bowl.

    A floured fish fillet being dipped into beaten egg
    Pass the floured fish through the beaten egg and let the excess fall away

    Finally, lay it in the coconut and press the flakes on gently so they stick all over. Repeat with the remaining pieces, always in the same order: flour, egg, coconut.

    Hands pressing coconut flakes onto an egg-coated fish fillet
    Press the coconut onto the egg layer so the surface is evenly covered
  4. 4Fry over medium heat until both sides are golden brown

    Heat canola oil in the skillet over medium heat and lay in the coated fish. Fry until golden brown on both sides. Watch the edge where the crust meets the pan as it starts to color.

    When the first side is golden brown, turn the fish with a thin spatula and fry the second side the same way. If the coconut darkens quickly before the fish has had time to cook through, lower the heat.

    The fillet turned in the skillet, browned crust facing up
    Turn the fish once the first side is golden, and fry the second side

    A golden crust does not tell you the center is cooked. Cook the fish to an internal temperature of 145°F (63°C). Without a thermometer, cook until the flesh is opaque and separates easily with a fork. Check the thickest piece.

  5. 5Drain, salt and serve warm

    Move the fish to paper towels to drain the excess oil, using a clean utensil and plate rather than anything that touched raw fish or egg.

    Scatter flake sea salt over the crust, add lime wedges on the side, and serve while warm. Do not pour any leftover marinade or beaten egg over the finished fish; discard them.

    Coconut fish on a plate with flake salt and lime wedges
    Finish with flake salt and lime wedges and bring it to the table warm