← Back to the recipe

Ingredients and steps on one page. Print it, or choose “Save as PDF” in the print dialog.

Sekai Gohan

Quindim: Brazilian Egg Yolk and Coconut Custards

Servings 8 piecesPrep 35 minCook 45 minTotal 1 hr 20 min

Finished quindim, yellow and glossy, arranged on a plate
Steps with photos

Ingredients

Ingredient Amount Substitutes & notes
Egg yolks 12 yolks (about 8 oz (220 g)) Do not use the whites. Strain out the white stringy membranes
Granulated sugar 8.5 oz (240 g) Soft white sugar works. Unrefined cane sugar gives stronger color and aroma
Unsweetened fine shredded coconut 2.5 oz (70 g) Chop coarse long-cut coconut with a knife to 0.25 inch (5 mm) or smaller
Unsweetened coconut milk ¼ cup (80 ml) Milk alone weakens the Brazilian-sweet aroma
Unsalted butter 25 g Melted. Prepare about 10 g more separately for the molds
Lemon zest Zest of 1/2 lemon Grate only the surface finely. The white part is bitter
Salt A pinch (about 0.8 g) Enough to tighten the sweetness. Do not overdo
Unsalted butter for the molds 10 g Brush into the ridges of the molds
Granulated sugar for coating the molds 3 tbsp Gives release and gloss. Knock out the excess
Hot water for the water bath 600–800 ml Enough to come halfway up the molds

Steps

  1. 1Butter and sugar the molds

    8 min

    Brush 10 g softened unsalted butter thinly into 8 metal molds about 2 inches (5 cm) across. Make sure the fat does not break at the bottom corners, the ridges of the sides, or the center post. Add 3 tbsp granulated sugar a little at a time, turning the molds, until the inside is coated white and gritty. Knock out the excess so no heap of sugar remains at the bottom.

  2. 2Rehydrate the coconut

    10 min

    In a bowl, combine 2.5 oz (70 g) unsweetened fine coconut, ¼ cup (80 ml) coconut milk, 25 g melted butter and a pinch of salt. Mix evenly with a silicone spatula. It is ready when the mixture is no longer white and powdery but slightly yellowish, like damp sand, and holds together loosely when pinched. Using long-cut coconut? Chop it to 0.25 inch (5 mm) or smaller and rest it in the bowl for 12 minutes so the moisture reaches the center.

  3. 3Strain the yolks and combine the batter

    12 min

    Put 12 yolks in a fine sieve and press lightly with the back of a spoon so they drop into a bowl. Don't rub hard; that pushes the membrane's odor through too. Discard the white strands left in the mesh. Add 8.5 oz (240 g) granulated sugar and the zest of 1/2 lemon, and stir gently about 30 times. Do not whisk. When the sugar grains are hard to see and the surface is smooth and yellow with no large bubbles, add the rehydrated coconut and mix evenly.

  4. 4Rest the batter and fill the molds

    35 min

    Cover the batter with plastic wrap and rest it 30 minutes. Keep it at room temperature if the room is under 77°F (25°C), or in the refrigerator on a hot day. While it rests, the coconut absorbs moisture and later settles gently to the bottom when baked. Just before filling, stir about 10 times from the bottom until the yellow batter and white coconut bits are evenly mixed, with no dry lumps at the bottom. Fill each mold to about four-fifths. Pop any bubbles on the surface with a skewer, and wipe batter from the rims with a damp cloth.

  5. 5Bake in a water bath

    35–40 min

    Arrange the molds in a deep heatproof dish or roasting pan. Pour in water at about 176°F (80°C) to come halfway up the molds. Put them in the oven preheated to 350°F (180°C). If the tops start to scorch, loosely cover them with aluminum foil after 20 minutes. They are done when the edges are set and only the center trembles slightly. Insert a skewer in the center. Stop when it comes out with a slightly damp film of egg, not liquid. If you bake until fully firm, they turn rubbery once cold.

  6. 6Cool and unmold

    20 min

    Take out the molds once the edges are set and the center is cooked through. Cool them 15 minutes on a wire rack or dry surface. While still warm enough to touch, run a thin knife once around the edge. Place a plate over the mold, flip in one motion, wait 10 seconds, then lift the mold. If it does not release, hold the outside of the mold in about 122°F (50°C) water for just 15 seconds, then flip again. It has worked if the surface is glossy and the coconut layer shows white at the base.