Pale batter goes into two silicone rings standing in a frying pan, filling them only a short way up the sides. Under the lid, small bubbles slowly rise across the surface. Then a spoonful of chunky red bean paste goes into the center of each, the rest of the batter covers it, and the cakes are turned so the second side can brown. The result is imagawayaki (今川焼き), a round Japanese sweet with sweet bean paste baked between layers of cake. This version makes two in an ordinary frying pan.
About Imagawayaki
In Japan, these cakes are usually cooked on a dedicated griddle with round wells. Here the griddle is replaced by two 3-inch (8 cm) diameter silicone molds made for a frying pan, plus an ordinary pan with a lid, and you cook one side at a time. The browning won't match a commercial cast-iron griddle, but you get clear amounts and a clear order of work for a first try.
What you're aiming for is simple: a thin first layer of batter, a mound of chunky bean paste set in the middle, and a second layer poured over the top. The bean paste stays enclosed in the center, and the cake comes out round.
Where Imagawayaki Comes From
Encyclopedias describe the cakes as being sold near Imagawa Bridge (今川橋) in Kanda, Edo (present-day Tokyo), from around the An'ei era in the mid-Edo period. A 1777 record lists "Imagawayaki Nasuya Yahei" (今川焼き 那須屋弥平). Who first made the cakes, and which shop sold them first, has never been confirmed, so the Imagawa Bridge account is best read as tradition rather than a settled origin. For other dishes from the same country, see more Japanese recipes.
Ingredients for 2 Cakes

These amounts fill two silicone molds 3 inches (8 cm) in diameter. The 3 inches (8 cm) is the width of the mold, not its height.
The oil goes on the pan only. No water is added to the pan for steaming; the lid alone holds in the heat.
This recipe contains wheat, egg and milk. Check the ingredient label on the bean paste you buy.
Equipment
- Frying pan with a lid
- 2 round silicone molds, 3 inches (8 cm) in diameter, made for heating in a frying pan (sold as rings for thick pancakes)
- Mixing bowl
- Whisk
- Sieve
- Small jug or ladle for pouring batter
- Heatproof spatula and heatproof tongs for turning and lifting
- Oven mitt
- Heatproof plate
Choosing the Mold and the Bean Paste
The mold is the part not to compromise on. It has to be one the maker says can be heated in a frying pan, such as a ring sold for thick pancakes; a mold labeled only as oven-safe won't do. Heat ratings differ from product to product, so follow the label on the mold you buy, and check its diameter there too.
The rest is ordinary shopping: cake flour, eggs, milk, sugar, baking powder, neutral cooking oil and ready-made chunky bean paste (tsubuan). In Japan these are everyday supermarket items, and any brand will do. Look for tsubuan at Japanese or other Asian grocery stores.
Method: Thin Base, Bean Paste, Top Layer, Turn
The cooking times below are about 10 minutes, then about 5 minutes, then 5–10 minutes after turning. Stoves, pans and molds vary, so watch the surface of the batter as well as the clock. Allow about 40 minutes for the whole job, including mixing and preheating.
Imagawayaki Troubleshooting
| What happens | Likely cause | What to do |
|---|---|---|
| The bean paste ends up to one side or shows at the edge | It was placed near the edge, or not pressed into the base | Set the paste in the center, away from the edges, and press it lightly into the first layer before pouring the rest of the batter |
| The surface is still wet with no bubbles when the time is up | Stoves and pans vary | Keep the heat low, cover again and keep cooking until the bubbles appear |
| The bottom browns too fast | Heat too high after preheating | Turn the heat down to low before the first pour, and don't leave the pan unattended |
| The cake shifts or slips while turning | Only the mold, or only the cake, was held | Support the cake from below with a spatula and hold the mold with tongs, then turn them together |
| The mold warps or softens | The mold isn't made for frying-pan heating | Use only molds labeled for heating in a frying pan, and follow their heat rating |
Serving Imagawayaki and a Variation

Imagawayaki are meant to be eaten freshly made, straight from the pan. The bean paste inside holds heat, so take care with the first bite. Cut one in half and you can see the paste sitting neatly between the two layers of cake.
A very different home version is Korokoro Imagawayaki (ころころ今川焼き). It uses a takoyaki plate to make twelve small, ball-shaped cakes with pancake mix, cocoa and cream cheese, and takes about 30–60 minutes for the whole job. It has its own tools and ingredients, so treat it as a separate recipe.
Frequently Asked Questions
Do I need a dedicated imagawayaki griddle?
Not for this recipe. Two 3-inch (8 cm) diameter silicone molds that can be heated in a frying pan, plus a pan with a lid, do the job. A griddle with round wells or a takoyaki plate calls for its own amounts and methods.
Should I oil the molds or add water for steaming?
No. Spread the oil thinly over the pan only, and cook with the lid on.
Why do the cooking times not add up to 40 minutes?
The roughly 40 minutes covers the whole job, including mixing and preheating. The times in the steps (about 10 minutes, about 5 minutes, then 5–10 minutes) are for each stage of cooking. Watch the surface rather than the clock, and keep the heat low.














